1. Press Program .

2. Press Set .

3. Press Time or to the correct hour of the day.

4. Press Set again.

5. Press Time or to the correct minute of the hour.

6. Press Set one time.

7. Press Time or to the correct day of the week.

8. Press Program . The time and day are now correct and the thermostat is running it's program. For manual operation without programming see the manual operation section. For programming see below.

Manual operation (not using the program):

1. Press Program .

2. Press to Heat, or Cool (avoid Auto mode), whichever you prefer.

3. Press .

4. Press the Red or Blue arrow key to set the temperature. The thermostat will hold whatever temperature it is set for.

5. Anytime you wish to change the temperature use the Red or Blue arrow key and the thermostat will maintain the new setting.

Programming the thermostat:

Fill out the schedules below. Fill in all the spaces.

You can repeat the same temperature more than once if you do not want the temperature to change over several time periods.

PROGRAMMING SCHEDULE

The programming of your thermostat is very easy following these steps. For more information see your programming and installation guide.

1. Follow the instructions above for setting the clock and the day of the week if it has not been set or is incorrect.

2. Press Program .

3. Press to select heat or cool, whichever you prefer to program at this time.

4. Press Program one time. This displays MOR and the settings for time and temperature. The display will also read MON for Monday.

5. Press Time or Time until the time on your display reads the same as you have selected in your Heating or Cooling Schedule. Be sure to check the AM or PM on the screen, it must also match your schedule. Proceed to next step.

6. Press the Red or Blue arrow keys to adjust the temperature to match your schedule.

7. Press Program to continue through all program periods (DAY, EVE, & NHT) entering times and temperatures for each period.To program the next day of the week, press ADV/DAY and repeat steps 5, 6 and 7. When you are satisfied your program matches your schedule you can press Program . Programming is now complete for this mode (Heating or Cooling, whichever you chose in step 3) and your thermostat is running your program.

8. If you wish you may return to step 3 to program the other (Heat or Cool) mode. When complete, press Program .

9. Press to Heat, Cool, or Auto and then press Program .

Congratulations, Your thermostat is now programmed and running the program you installed. To override the program temporarily press the Red or Blue arrow keys. To operate the thermostat manually see above.